Available options depend on your version, permissions and hardware. For missing actions, see Security and Diagnostics.
Step by step
- Open the collector flashing tool; use a Web Serial compatible browser in HTTPS or localhost.
- Connect USB, select the correct device/firmware and keep it connected during flashing.
- Configure Wi-Fi, local/remote destination and RS485 RX, TX, DE/RE pins; assign the collector to equipment.
Options explained
- Local
- the core must be reachable; discovery may fail across subnets.
- Remote
- requires active remote access and the configured destination.
- DE/RE
- -1 is for automatic direction boards; otherwise use the board's correct pin.
- Forget
- removes the record, not necessarily firmware. Check readings after hardware changes.
Troubleshooting
For USB issues, check browser support and secure context. If the collector appears but has no inverter readings, check bus, driver and device address.
Common problems